Reducers (BPV, Sec. VIII, Div. 1, UG-32(g))
Design conditions
Project name
Design pressure
P = [psig]
Design temperature
T = [°F]
Material
Name
Maximum allowable stress
SE = [ksi]
Component geometry
Large end diameter
D1 = [in]
Small end diameter
D2 = [in]
Thickness
tnom = [in]
Length (end-to-end)
H = [in]
Analysis point
x = [in]
Diameter at the analysis point
Dx = [in]
Half apex-angle of the cone
α = [deg.]
Factors/Tolerances
Weld joint factor
W = [-]
Additional thickness
A = [in]
Manufacturer's thickness tolerance
Mill = [%]
Results
Minimum wall thickness
T = [in]
Pressure design thickness
t(x) = [in]
Minimum required thickness
tm(x) = [in]
Condition (T ≥ tm(x))
-
Maximum allowable pressure
MAWP(x) = [psig]